Screen Change For RAPT Fermentation Chamber

Swapping the KL17091 TFT RAPT - Fermentation Chamber - Screen Board is quite a simple process.

Please refer to the following instructions should you need to swap the Screen Board for any reason.

WARNING: Ensure the RAPT Fermentation Chamber is unplugged before proceeding

First, remove the top beer and gas line cover.

Use the tab to release the top cover as shown

Next, use a Philips screwdriver to remove thee two screws

Now, remove screws from the underside of the screen as shown here

Remove the left and right side covers by sliding them away from the fridge as show below

Slide the screen down so you can see the cables behind the screen

Unplug the cables from the screen PCB board

Remove the four screws holding the screen board in place

If you are replacing the screen PCB board with a new one make sure to remember to remove the protective film before putting the new board into position

Finally, simply reassemble the unit following the same steps in reverse order.