Remote Operation with the RAPT Portal
Remote Operation | RAPT Gen 4 BrewZilla
Last updated
Remote Operation | RAPT Gen 4 BrewZilla
Last updated
All RAPT devices are designed to be used in conjunction with the RAPT Portal. Once connected to WiFi and registered to the RAPT Portal, a world of powerful customisation opens up for the user.
The RAPT Gen 4 BrewZilla can be controlled through the RAPT Portal in two different ways.
Manual Control can be enabled in the Dashboard of the RAPT Portal.
Enabling Manual Control gives the user limited, real time control of the RAPT Gen 4 BrewZilla directly through the RAPT Portal.
The other way to control the RAPT Gen 4 BrewZilla is through the use of Brewing Profiles.
Profiles alllow you to create powerful, complex but easy to setup and use brewing profiels. The use of Profiles allows brew day to be nearly hands off, even with (for example) complex step mashes. Incorporating steps for pre heating strike water, mash out etc are simple to set up and run through the RAPT Portal.
For a guide to setting up and running Brewing Profiles on the RAPT Gen 4 BrewZilla please refer to Profiles
To Enable Manual Control of the RAPT Gen 4 BrewZilla it must first be connected to WiFi and registered to the RAPT Portal.
Once registered, select the RAPT Gen 4 BrewZilla in the Dashboard of the RAPT Portal.
Select the Manual Control option in the Display Options of the RAPT Gen 4 BrewZilla.
This will display the Manual Control screen of the RAPT Portal Dashboard
From here, various controls can be selected and switched on or off. These changes will be instantly enabled on the RAPT Gen 4 BrewZilla.
Target - this is the desired target temperature
Heating % - this is the desired heating power percentage (NOTE: If Distillation Mode is enabled the closest available percentage power will be automatically selected)
Pump % - this will cycle the pump on or off at the selected rate
ENABLE HEATING - This turns the RAPT Gen 4 BrewZilla's heating elements on or off
ENABLE PUMP - This turns the RAPT Gen 4 BrewZilla's built in pump on or off
ENABLE PID - This enables or disables PID. PID settings can then be set directly in the Manual Control screen
The current temperature and the Set Point temperature are displayed at the bottom of the Manual Control screen
