The RAPT Laser Level Sensor - Cornelius Keg Lid Kit is pre-assembled
Before use inside a suitable Cornelius keg (such as a KegLand 19L or 9.5L Ball Lock Keg) please clean the underneath of the pre-assembled lid and housing, and ensure the keg lid and keg are both clean and sanitised before use.
The RAPT Laser Level Sensor - Cornelius Keg Lid Kit is rated to IP68.
Before use, the batteries must be installed in the battery holder. The battery holder must then be correctly installed in the RAPT Laser Level Sensor.
Installing Batteries
1
Remove Top Housing
Carefully unscrew the top housing from the RAPT Laser Level Sensor. Remove the battery housing and board assembly as shown.
2
Remove the Battery Housing
Carefully pull out the battery housing. Install 3 x AAA Batteries, ensuring correct polarity. The Negative terminal is indicated by springs in the battery housing as shown
3
Install the Battery Housing
Once the batteries have been installed in the battery housing, replace the housing in the Board Assembly. Note: The battery housing is directional. Follow arrows as indicated on housing. Line up the battery housing with the board housing as shown
4
Install the Board Housing into the RAPT Laser Level Sensor
Carefully replace the Board Housing into the RAPT Laser Level Sensor housing. Screw the top housing back onto the RAPT Laser Level Sensor housing, ensuring that it is snug as pictured.
Once the battery housing is installed the RAPT Laser Level Sensor will automatically enter Bluetooth Pairing mode for approximately 5 minutes, allowing it to be registered to the RAPT Brew App. Bluetooth Pairing Mode is indicated by the LED blinking Blue
If the RAPT Laser Level Sensor does not enter Bluetooth Pairing mode then this can be entered manually - refer Operation
To Register the RAPT Laser Level Sensor to the RAPT Brew App refer to Registration
