> For the complete documentation index, see [llms.txt](https://docs.rapt.io/llms.txt). Markdown versions of documentation pages are available by appending `.md` to page URLs; this page is available as [Markdown](https://docs.rapt.io/equipment/polyphoenix-air-still-pro-table-top-distillation-kit-user-guide/troubleshooting.md).

# Troubleshooting

KB51193 PolyPhoenix Air Still Pro  | Troubleshooting

| Problem                                          | Possible Cause                         | Solution                                                                                                                                   |
| ------------------------------------------------ | -------------------------------------- | ------------------------------------------------------------------------------------------------------------------------------------------ |
| **Still slow to produce distillate**             | Boiler/head seal not sealing           | Check that the silicon seal is clean and undamaged. Check that the adjustable clamps are sufficiently snug                                 |
|                                                  | Reflux run - dirty packing             | Remove and clean packing if required                                                                                                       |
|                                                  | External boiler - not enough power     | Use an external power controller to provide sufficient power to boil the wash without overwhelming the still head                          |
| **No distillate produced**                       | Wash not boiling                       | The wash will take time to come to a boil and start producing                                                                              |
|                                                  | Collection jar not filled              | No distillate will be produced until the collection jar is filled (or removed)                                                             |
|                                                  | Incorrect use of collection jar        | If the collection jar is emptied and replaced it will need to fill again before further distillate is produced                             |
| **Leaking from column (next to collection jar)** | Column flooded                         | Reduce boiler power. Remove and clean packing. Use clarifying agents for the wash                                                          |
|                                                  | External boiler - too much power       | Use an external power controller to provide sufficient power to boil the wash without overwhelming the still head                          |
| **Run stops early**                              | Incorrect mode/End Temperature too low | The unit will shut off at the set End Temperature - 98°C for Pot Still mode and 82°C for Reflux. This temeprature can also be set manually |
| **Ethanol Alarm tripping**                       | Boiler/head seal not sealing           | Check that the silicon seal is clean and undamaged. Check that the adjustable clamps are sufficiently snug                                 |
|                                                  | Vapour escaping                        | If the column is flooded or overwhelmed the ethanol alarm may trip                                                                         |
|                                                  | Ethanol sensitivity too low            | This should be left at the default setting to ensure safety.                                                                               |
